D3D printer with 12", insulated heatbed. This is the next to last iteration of build prior to upgrading to the single-piece 3D printed axis pieces.
New idler mount - FreeCAD -File:Newidlermount.fcstd
D3D v2004 Assembly - FreeCAD -File:D3d v2004.fcstd
Using 3D Printer Workbench 2020:
-  22” - X
-  21” - Y
-  17” Z, bed, spool holder
Heater Element Wrapping Procedure
- Cut 14' of ga 24 nichrome
- Cut 5' of tight 2 mm fiberglass sleeve
- start the wrap of nichrome on one end of sleeve
- Attach other end of sleeve to a free-spinning rotor
- Once enough to go inside a cordless drill chuck - grab the nichrome wrap and turn on the drill in reverse to start wrapping. Tension the sleeve against the rotor
- Wrap away! A person should be able to wrap 4 feet long just by holding a cordless drill
-Back to working some on PVC 12" - was there enough torque to lift that bed with 2 Z steppers? I don't seem to have enough with properly tightened axis.