Ironworker/Bill of Materials: Difference between revisions
Jump to navigation
Jump to search
(Created page with "{{ToolTemplate|ToolName=Ironworker}} ==Bill of Materials== *5"x8" hydrauilic cylinder *[2]1"x4" pin - for mounting cylinder *[2]3/4" or 1" washers *[2] 1"x10"x48" plate - main ...") |
No edit summary |
||
| Line 1: | Line 1: | ||
{{ | {{GVCS Header}} | ||
==Bill of Materials== | ==Bill of Materials== | ||
| Line 17: | Line 17: | ||
*2.5" DOM tubing, 4" long - for main pin | *2.5" DOM tubing, 4" long - for main pin | ||
*2.5" shaft, 5" long - main pin | *2.5" shaft, 5" long - main pin | ||
{{GVCS Footer}} | |||
Revision as of 01:01, 6 September 2011
| Ironworker | ||
|---|---|---|
| Home | Research & Development | Bill of Materials | Manufacturing Instructions | User's Manual | User Reviews | 
| |
Bill of Materials
- 5"x8" hydrauilic cylinder
- [2]1"x4" pin - for mounting cylinder
- [2]3/4" or 1" washers
- [2] 1"x10"x48" plate - main parallel pieces
- [2] 1"x10"x32" plate - vertical supports
- [2] 1"x2"x3" plate - for reinforcement of pressing surface
- [4] 3/8"x4"x6" angle, 6" long - for legs
- [2] 1"x5"x5" plate - for alignment tube
- [2] 1"x4"x8" plate - for dye holders
- DOM tubing to hold die - 2" long
- Smaller DOM tubing to support die from underneath
- 2.5" DOM tubing, 5" long - for alignment
- 2.5" shaft, 7.7" long - for pressing
- 2.5" DOM tubing, 4" long - for main pin
- 2.5" shaft, 5" long - main pin
